Contact Us

You can use the contact form on our “About” page, or use the form below regarding any tool that interests you.
Please make sure you complete all the information asked for otherwise we will not receive it.

We will be at the BEAULIEU INTERNATIONAL AUTOJUMBLE on the 2nd and 3rd of September   at our usual pitches of R753 R754 R783 and R784 in RED field please check the news column for more details. Look forward to seeing all our customers there.

Tel: 01235 763987
Fax: 01235 769828

Browse our site

Reset

WHEEL AND PINION CUTTING ATTACHMENT

WHEEL AND PINION CUTTING ATTACHMENTWHEEL AND PINION CUTTING ATTACHMENT This attachment was  built to the design by Colin Walton and will fit onto the bed or crosslide of a lathe such as a 10 mm 1660 Pultra or Myford. The cutter would be held on an arbor which would be held in the three jaw chuck or in a collet, the wheel or pinion to be cut is held on the end of the spindle and moved up and down to cut the wheel. A picture detailing the set up is to be found in J Malcolm Wild`s excellent book Wheel and Pinion Cutting in Horology. The attachment is in excellent condition and has the following counts 144. 120. 100, 96. 90. 84. 80. 78. 68. 64. 62. 59. and pinion counts  of 12. 8. 7. These can be divided up even further to give most counts that will be needed. The attachment is shown set up to cut  pinions. A good investment and good value. Buyer collects or arranges collection Built in Britain Built to Last™. NOW SOLDWheel and pinion cutting attachment by Colin Walton 001

Ask a question

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>

  

  

  

− 3 = 2