PULTRA 1750 10MM BENCH LATHE
A well equipped clean bench model which just needs mounting on a bench with the Mardrive unit to be used straight away. The Mardrive is single phase 240 volt with switch gear and clutch and brake pedal. Comes with the following equipment:-
- Set of 24 metric collets from .4 – 7.5 mm
- Set of 9 extended collets 8 – 16 mm
- 3 Blank collets
- Set of 5 ring chucks
- 4 Jaw chuck
- 3 Jaw chuck with reverse jaws
- 2 Single point toolholders
- Quick change tool block with seven toolholders
- Tip over tool rest and spare rest
- Tool rising block
- 5 Carriers
- Catch and drive plate for above
- Spanners
- Tool bits
- Nose mounted box chuck
- Collet box chuck
- Oil Gun
- Saw table
- Tailstock centre collet
- Crosslide
- Lever crosslide
- Lever Drilling Tailstock
- 2 x Saw Arbour
- Drill chuck
- Collet die holder
All slides and lathe bed are in excellent condition The quick change toolholder has been homemade by an engineer and is well executed.Built in Britain Built to Last™. Very Good Value. Buyer collects or arranges collection . This Pultra was sold to a customer of ours in 2017, and has since had a change of direction in his interests so we are selling it for him. Please call if you require any further information.
NOW SOLD
Ask a question