Contact Us

You can use the contact form on our “About” page, or use the form below regarding any tool that interests you.
Please make sure you complete all the information asked for otherwise we will not receive it.

Tel: 01235 763987
Fax: 01235 769828

Browse our site

Reset

HOME CONSTRUCTED WHEEL AND PINION CUTTING ENGINE

HOME CONSTRUCTED WHEEL AND PINION CUTTING ENGINEHOME CONSTRUCTED WHEEL AND PINION CUTTING ENGINE

A superbly constructed wheel cutting engine that was exhibited at the Diamond Jubilee Model Engineering Exhibition held at Alexander Palace. The constructor was a keen horologist and made this one from drawings with a few additions. Mounted on a three draw cabinet which contains all the accessories, controls and mains lead and spare belting. The 4 Count plates are made from an aluminum alloy and countain over 51 seperate counts with the low counts from 3 – 15. The 8 pairs of collets are for holding pinions when the gallows is set up and has 2 spare pairs and a centering pin as well as suport jacks. Wheels are held on spindels with hexagonal form and are screwed into the same location as the collets. There are 6 imperisl sizes from 1/8″ – 3/8″ and 6 metric sizes from 3mm – 8mm. There are four cutters that came with the machine :- .75  8 teeth  .7 wheel .6 wheel .75 wheel maximum size of wheel that can be cut is 71/4″ dia. The overall size of this Machine is 24″ long by 12″ wide and 9″ high Total height including the cutting slide lever is 19″high. We have run this unit and would recommend a motor upgrade which we would supply. Overall an exceptionaly built machine that will give years of service. Please call us for any further information and price on 01235 763987. Built in Britain Built to Last™, Buyer collects.

NOW SOLD

P1760257P1760258P1760260

Ask a question

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>

  

  

  

− 2 = 4