PULTRA 1750 10MM PRECISION BENCH LATHE

PULTRA 1750 10MM PRECISION BENCH LATHE

PULTRA 1750 10MM PRECISION BENCH LATHE

This is one of the many war finish lathes that made instruments and parts in the underground factories in our last conflict. This one escaped hard use and has survived to serve its last owner well. A little oil staining on some parts  which is to be expected after storage but is only cosmetic.The headstock bearings are without wear and the crosslide screws have very little backlash if any. It has the hard to find detent plates that fit the back of the lathe spindle or the milling/grinding spindle with the two adapter bushes. The detent fingers are mounted on the back of the headstock or on the milling spindle body. Drive unit is the standard clutched Mardrive 240 volt single phase with counter shaft ( not shown) Comes with the following equipment:-

• Vertical slide with front plate
• Milling /Grinding spindle
• Detent plates and fingers
• 4 collets for spindle
• Crosslide with 4 Tool holders
• Tip over tool rest
• Rising block
• 4 jaw chuck
• 3 jaw chock
• Slitting saw arbor
• 7 extended nose collets
• 18 x 10mm  imperial collets
• 15 x 8mm collets for lever tailstock
• Catch plate and five dogs
• 3 male centers
• 3 female centers
• Tools etc

Overall a very well equipped package that would suit a Model engineer or Horologist. Buyer collects.

NOW SOLD