Contact Us

You can use the contact form on our “About” page, or use the form below regarding any tool that interests you.
Please make sure you complete all the information asked for otherwise we will not receive it.

The next event we will be attending will be at the Midlands clock and watch fair on Sunday the 18th March. Held at the National Conferance Centre. ( used to be known as The Motorcyle Museum )

Tel: 01235 763987
Fax: 01235 769828

Browse our site




This one has been stored for some time hence there is a little oil staining on some of the surfaces, however ther are no nicks or cuts to the bed and overall the lathe is in very good condition and mechanically sound. The headstock spindlenose is threaded 14 X 1mm and there is no play in the headstock bearings or countershaft. Powered by a 240 volt mains reversable motor ( as suplied by Cowells ) the whole set up will need mounting on a bench or board.  It comes with the following equipment:-

  • Emco reversable 3 jaw chuck
  • Cowells 4 jaw chuck
  • Face plate
  • 4 Imperial collets
  • 4 Metric collets
  • Collet holder
  • Live Center
  • rising block & 2nd toolblock
  • 2 Dead centers
  • 1/2 dead center
  • Tailstock chuck
  • Diestock holder
  • 14 gears
  • Fixed steady
  • varous tools and drive belts

The lathe runs well and would suit a model maker or Horologist Built in Britain Built to Last™. Please call us for any further information very good value.Buyer collects or arranges collection.


Ask a question

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>




+ 35 = 36