Contact Us

You can use the contact form on our “About” page, or use the form below regarding any tool that interests you.
Please make sure you complete all the information asked for otherwise we will not receive it.

We will be at the BEAULIEU INTERNATIONAL AUTOJUMBLE on the 2nd and 3rd of September   at our usual pitches of R753 R754 R783 and R784 in RED field please check the news column for more details. Look forward to seeing all our customers there.

Tel: 01235 763987
Fax: 01235 769828

Browse our site

Reset

EMCO TOOLPOST GRINDER

EMCO TOOLPOST GRINDEREMCO TOOLPOST GRINDER

This compact toolpost grinder uses the high speed clockmakers spindle that fits into the unimat lathe and takes 8mm collets as well as the internal and external spindles ( shown mounted with the both guards off )the spindles are machined to take a wheel with a bore of . 6270 in 15.92 mm for External grinding and a bore of .1690 in 4.30mm for Internal grinding . The 240 volt single phase motor drives a 3 speed pully via a v belt. This model is suited to smaller lathes like the Myford but can be fitted to others. It will need a suitable T bolt and spacers to clamp to a slotted table or just spacers to fit an exsisting crosslide clamp. As you would expect this is very well made and in very good condition. This grinder weighs in at 7kilos and we will post UK only by Royal Mail Special Delivery including packing at cost for £30.00, otherwise buyer collects or aranges collection .

NOW SOLD

Ask a question

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>

  

  

  

8 + 2 =