PULTRA 1750 PRECISION LATHE

PULTRA 1750 PRECISION LATHE

PULTRA 1750 PRECISION LATHE

A good example of this well known and much used lathe which can be found in horological and model makers workshops across the country. This one is in its original colour scheme. This came from a clock makers workshop and has been used (but not abused) and bears the usual marks on the bed, the T slot on the crosslide has been damaged but with the four way tool post is completely usable. This one has been fitted with the 24 point dividing ring and detent pin at the rear of the headstock, there is also a counter shaft with it and We will supply a single phase 240 volt mains motor (1425.00 rpm) and a suitable pulley with the machine ( it did not come in with one). It comes with the following equipment:-

• 23 collets mostly metric
• 5 piece ring chuck set
• crosslide with 4 way tool post
• 3 jaw Bernard chuck
• Lever drilling tailstock
• Mandrel face plate and center pin
• Tip over tool rest withe rest and roller rest
• a very rare drop arm Jacot drum

The headstock bearings show no signs of wear and the crosslide screws have very little backlash in them. This lathe will give good service to the next user. Built in Britain Built to Last™. Buyer  collects or arranges collection. please call us if you require any further information.

NOW SOLD