Oops! It appears that you have disabled your Javascript. In order for you to see this page as it is meant to appear, we ask that you please re-enable your Javascript!

Contact Us

You can use the contact form on our “About” page, or use the form below regarding any tool that interests you.
Please make sure you complete all the information asked for otherwise we will not receive it.

Tel: 01235 763987
Fax: 01235 769828

Browse our site

Reset

GARVIN 70mm 4 JAW CHUCK

GARVIN 70mm 4 JAW CHUCK

GARVIN 70mm 4 JAW CHUCK

A new old stock 70mm independent 4 jaw chuck, mounting thread is 14 X 1mm so will fit late Cowells lathe, boxed with to keys. Will post UK only Royal mail Special delivery inc packing for £11.00 or Buyer collects.

NOW SOLD

[…]

BOLEY & LEINEN RING CHUCKS

BOLEY & LEINEN RING CHUCKS

BOLEY & LEINEN RING CHUCKS

A very clean set of 5 ring chucks. All edges are sharp and no damage to the ring steps. Would appear that they have had very little use. Will post Uk only Royal Mail Special delivery including packing for £10.00.

NOW SOLD

[…]

SMALL 3 JAW CHUCK

SMALL 3 JAW CHUCK

SMALL 3 JAW CHUCK

A 49 mm diameter 3 jaw chuck with reversable jaws internal diameter and thread is 14 X 1 mm so would suit late Cowells. This chuck looks brand new, Has no manufactures mark so is of unknown origin. Will post UK only Royal Mail Special Delivery only including packing for £7.00, […]

SMALL 3 JAW CHUCK

SMALL 3 JAW CHUCK

SMALL 3 JAW CHUCK

A 45mm diameter 3 jaw chuck with reversable jaws mounted on an 8mm arbour ( Internal thread of chuck is 12X1mm). No makers name on this one so can only assume it`s from the east. Suitable for general work and holding items for polishing etc. Has not been used as far […]

59 mm 4 JAW INDIPENDENT CHUCK

59 mm 4 JAW INDIPENDENT CHUCK

This chuck is colleted and will fit a 10mm Pultra lathe, collet could be unscrewed and others fitted, the chuck has a 12 x 1mm internal thread. It has good clean sharp jaws and the overall condition is good, a key is supplied but isnot the original. Will post […]

60mm TML KEY SCROLL CHUCK

60mm TML KEY SCROLL CHUCK

A 60mm scroll chuck with key as used on the early Cowells lathe. There is no adaptor with this chuck but the recces in the rear is 22mm in diameter X 8mm deep with three athree point mount. These chucks have excellent grip effected by the key. Woud be suited […]