Contact Us

You can use the contact form on our “About” page, or use the form below regarding any tool that interests you.
Please make sure you complete all the information asked for including a contact number otherwise we will not be able to reply.

Tel: 01235 763987

Bushing Tool required, K W M or Bergeon would be ideal, as complete as possible with cutters broach`s, gauge and bushes in good condition.  Money waiting for the best example. Also Chronos/Boyle/Corrie or any wheel or pinion cutting engines,  Money awaits the best example.

 

Search Categories



FOR SALE

MEDDINGS 1/2″ BENCH DRILL

MEDDINGS 1/2" BENCH DRILL

MEDDINGS 1/2″ BENCH DRILL

This industrial quality 415 volt 3 phase bench drill has 3/4 hp motor and is in superb condition. It has 4″ quill movment and is able to take 2 Morse drill or chucks. The T slotted table has coolant drain as well as the base. Light under the chuck to the [Read more…]

MEDDINGS PACERA BENCH DRILL PRESS

MEDDINGS PACERA BENCH DRILL PRESS

MEDDINGS PACERA BENCH DRILL PRESS

This 1/2″ capacity model has been used but well looked after with just a couple of nicks on the adjustable table. The drive is by a single phase 240 volt 1/3 HP motor to a 5 speed pulley set giving the following speeds 500, 900, 1400, 2300, and 4000 rpm [Read more…]

PROXON BSG 220 DRILL SHARPENER

PROXON BSG 220 DRILL SHARPENER

PROXON BSG 220 DRILL SHARPENER

In as new condition, we believe it`s never been run.This drill sharpener will accurately produce standard 118 degree drill points and the correct relief angle. It can take drills from 3 mm – 13 mm and includes a dressing stone for truing the wheel. Good value and well made.

NOW [Read more…]

WHITECOTE 16 MM DRILL PRESS

WHITECOAT 16 MM DRILL PRESS

WHITECOTE 16 MM DRILL PRESS

A clean 12 speed model with a 2 morse quill enabling drills to be mounted directly. Speed range is from 210 rpm – 3650 rpm. the 10″ x 10 ” table is clean and without extra holes, it tilts o – 45 degrees both ways and can be wound up [Read more…]

PINNACLE BENCH DRILL

PINNACLE BENCH DRILL

PINNACLE BENCH DRILL

This model come withe 12 speeds from 110 rpm – 3110 rpm and is powered by a G E C 1/2 HP 220 – 240 volt single phase motor. Drills are held in a 2 Morse quill, or by a 3 jaw Jacobs style chuck ,the quill 3 1/2″ of travel . [Read more…]