COWELLS 90ME LATHE
A very well equipped example of this well known and widley used British made lathe. It is the older version with a 14X 1.25 mm nose thread,however the dividing head nose thread is 14X1.00mm. This one comes with the wheel and pinion cutting attachment and was set up to be used this way when collected. It will need a tailstock drilling chuck and came without the guard over the the drive system, these can easily be obtained from Cowells if required. This lathe is in a ready to be used state and is very good value for somebody taking up clock making or small scale model engineering. Please contact us for further details. Buyer collects or arranges collection. Built in Britain Built to Last™.
NOW SOLD
- 3 Jaw chuck (reversable jaws)
- 4 jaw chuck
- Vertical slide
- Milling & Wheelcutting spindle
- Vice
- 3 Jaw chuck & draw bar forspindle.
- 3 Detent Plates and detent pin and arm.
- Dividing head with B&D plates.
- Rising block.
- Saw Table and cutter spindle.
- 2 Wheel blank holders.
- 4 Wheel cutter arbours
- Fly Cutter
- Pivot plate attachment & plate
- 3 Jacot drums.
- Collett holder and metric collets.
- 2 Fixed centers male.
- 2 fixed centers female.
- Live center.
- 4 way tool holder
- Single point tool holder.
- Fixed steady.
- 2 Die holders
Ask a question