Contact Us

You can use the contact form on our “About” page, or use the form below regarding any tool that interests you.
Please make sure you complete all the information asked for otherwise we will not receive a reply.

 

Tel: 01235 763987
Fax: 01235 769828

Browse our site

Reset

VERTICAL WHEEL AND MILLING ATTACHMENT

VERTICAL WHEEL AND MILLING ATTACHMENT

VERTICAL WHEEL AND MILLING ATTACHMENT

An unusual and versatile wheel cutting and very light milling attachment that would be most suited on WW pattern lathe beds. Fitted with a small arbour to take 4.5mm bore wheel cutters, this can be removed and others made to hold other cutters [Read more…]

ACIERA F12 UNIVERSAL PRECISION MILLING MACHINE.

ACIERA F12 UNIVERSAL PRECISION MILLING MACHINE.

Here we have an incomplete example of this forerunner of the iconic F1. Despite it`s unkempt appearance underneath the grime and staining is a very useful basis for an accurate horizontal miller. There is little wear in the slides and the handles and the leadscrews are not bent. The [Read more…]

COWELLS 90ME LATHE

COWELLS 90ME LATHE

COWELLS 90ME LATHE

A very well equipped example of this well known and widley used British made lathe. It is the older version with a 14X 1.25 mm nose thread,however the dividing head nose thread is 14X1.00mm. This one comes with the wheel and pinion cutting attachment and was set up to be used this [Read more…]

EMCO UNIMAT 3 PRECISION LATHE and MILL

EMCO UNIMAT 3 PRECISION LATHE and MILL

EMCO UNIMAT 3 PRECISION LATHE and MILL

A very clean and well equiped model of this popular all rounder. This one takes Chronos dividing plates on the back of the headstock spindel No`s DD62 & DD63 ( as well as having the emco dividing unit and 4 plates ) so wheels and pinions can be [Read more…]

SCHAUBLIN 102 PLAIN LATHE

SCHAUBLIN 102- 80 PLAIN LATHE

This 1956 model Bl 92430 FAB 149 has a plain bearing W20 headstock and was used exclusively for the restoration of clocks and instruments, we are selling this on behalf of one of our customers and considering its age is in very good condition, would benifit with a repaint! [Read more…]

POTTS MILLING AND DRILLING SPINDLE

POTTS MILLING AND DRILLING SPINDLE

POTTS MILLING AND DRILLING SPINDLE

An unpainted example of this home constructed spindle. It can be attached to most vertical slides, lathe crosslides and some wheel cutting engines. The spindle takes 8mm collets and has a two speed pulley. This has seen very lttle use and has no play on the bearings. Made in Britain Built to Lastâ„¢ weighs in [Read more…]

J.M.WILD WHEEL CUTTING & MILLING SPINDLE

J.M.WILD WHEEL CUTTING & MILLING SPINDLE

J.M.WILD WHEEL CUTTING & MILLING SPINDLE

This sets the standard for wheel cutting and milling spindles. Built to a very high standard with pre – loaded bearings and heavy duty construction they give years of service. It will fit straight on to the Myford vertical slide with the aid of extended T bolts, but will [Read more…]

MILLING SPINDLE

MILLING SPINDLE

This Spindle is likely to be an early model by Arund Engineering the latter models were of sqaure construction with the mounting holes drilled through the block and will fit straight on to a Myford vertical slide. They were very well made in solid cast iron with high quality bearings. The spindle will [Read more…]