FOR SALE
|
MYFORD ML 7 A good clean example of this early model of the Myford range. This one has been upgraded with an imperial gearbox giving it greater versatility on it`s screw cutting and feed range . On a Myford stand and drip try it comes with a 4″ 3 jaw chuck ,6″ 4 jaw chuck, [Read more…] 
BERGEON CASE BACK PRESS This case back opening press comes with following sets of holders and opening pins:- Set of Rolex milled rings and intermediate holder for opening oyster watch cases. Bergeon No 5538. Set of 8 Reversible case holding jaws for watch cases with end pieces “Couvre – Anses” Bergeon No 5700 RU Set [Read more…] 
WATCH CASE OPENING PRESS No makers name on this one, but is complete. The press body tool which is mounted on the wooden base is made of cast iron so will be rigid in use. comes with the following equipment. 3 Watch holders 1 watch holder with interchangeable plates 6 off which are reversible. 8 [Read more…] 
MICRO MILL/DRILL This Chester micro mill/drill is compact and will be able to perform a wide variety of tasks, and will be very much at home in the model engineers or Horologist workshop. It has a high and low range of variable speeds 0-3600 and 0-5000 rpm this achieved by a simple belt change and [Read more…] FAVORITE STAKING SET This well know Swiss manufacture made high quality tools that were as good as Bergeon, not found so much these days. This one although used is in very good condition and would be ideal for some one starting out in the repair business. This one has the inverto block and a good [Read more…] WARCO Z X 15 MILL This versatile small vertical mill can positioned in a large variety of configurations ( it can at a push be used in the horizontal position ) . The mill has had very little use with the table being in pristine condition. It comes with the following equipment and specification. Single [Read more…] 
DRAPER D 16/16 BENCH DRILL PRESS This model has the 12″ round table with rack rise and fall and tilt facility, with 16 speeds ( 210-3340 ) and its 350 watt 1/2 HP motor it can take on most jobs in any model engineers workshop. This also has a No 2 Morse sleeve quill which [Read more…] 
BOXFORD ME 10 CENTRE LATHE A very clean example of this late 5″ x 22″ model from the Boxford company.This one is the metric version, not on the makers stand but on a home constructed one but with the original chip and suds tray. The Speed range starts at 60 rpm and goes to 2100 [Read more…] 
WOLF JAHN VERTICAL SLIDE This 8 mm model has 50 mm vertical movement , the spindle block can rotate 360 degrees so any cutting angle can be achieved. The base is also able to rotate around its single clamping point. The nickle plating is a little worn in some areas but is in very good [Read more…] 
MYFORD PLAIN VERTICAL SLIDE This is original Myford, comes with 2 tee bolts and it`s box , excellent condition as new. This was Sold at the Birmingham Clock Fair
|
|
|
Copyright © 2024 Pennyfarthing Tools Ltd - All Rights Reserved | Design: Macwiz Powered by WordPress & Atahualpa |
||
