FOR SALE
|
POTTS MILLING AND DRILLING SPINDLE An unpainted example of this home constructed spindle. It can be attached to most vertical slides, lathe crosslides and some wheel cutting engines. The spindle takes 8mm collets and has a two speed pulley. This has seen very lttle use and has no play on the bearings. Made in Britain Built to Last™ weighs in [Read more…] 
BOLEY & LEINEN WW PATTERN 8 MM LATHE This early Boley and Leinen ww pattern lathe follows the American style single foot models. This has seen long service and cosmeticaly it shows it. It would benifit from a strip down and a good cleaning. It comes well equiped with the following :- 27 8mm collets [Read more…] 
EMCO TOOLPOST GRINDER This compact toolpost grinder uses the high speed clockmakers spindle that fits into the unimat lathe and takes 8mm collets as well as the internal and external spindles ( shown mounted with the both guards off )the spindles are machined to take a wheel with a bore of . 6270 in 15.92 [Read more…] 
GEO.H.THOMAS SENSITIVE DRILL A very well built example of this popular drill which is firm favorite with horologists and model makers . The footprint of this machine is 375mm X 290mm and 420mm high. The quill travel is 24mm and is fitted with a Jacobs N0 chuck which will take up 5/32 drills. The diameter [Read more…] 
COWELLS 90E LATHE This one has been stored for some time hence there is a little oil staining on some of the surfaces, however ther are no nicks or cuts to the bed and overall the lathe is in very good condition and mechanically sound. The headstock spindlenose is threaded 14 X 1mm and there [Read more…] 
J.M.WILD WHEEL CUTTING & MILLING SPINDLE This sets the standard for wheel cutting and milling spindles. Built to a very high standard with pre – loaded bearings and heavy duty construction they give years of service. It will fit straight on to the Myford vertical slide with the aid of extended T bolts, but will [Read more…] 
MILLING SPINDLE This Spindle is likely to be an early model by Arund Engineering the latter models were of sqaure construction with the mounting holes drilled through the block and will fit straight on to a Myford vertical slide. They were very well made in solid cast iron with high quality bearings. The spindle will [Read more…] 
SMALL INDEXING HEAD This small indexing unit only measures 2 1/4″ X 1 1/4″ x 2 1/42 high and would fit well on any high precsion mills such as the Aceria F1 or the Sixis or any other smaller millers. Made to a very high standard ( We have not been able to identify a [Read more…] 
LORCH JUNIOR 8mm WATCHMAKERS LATHE A good example of this model very quite running lathe ( fitted with a PAPST motor that is also fitted to the Boley F1 ). The feed screws on the crosslide are reversed (They turn right instead of left). The 240 volt single phase motor has an is controlled by [Read more…] 
BERGEON 8 MM STANDARD A SET A completely original model with everything intact. This highly desirable lathe from the Bergeon dynasty is being sold on behalf of one of our watchmakers clients and has been treated with respect that it deserves. Comes with the following :- Crosslide with standard tool holder 3 Jaw chuck with [Read more…] |
SOLD
|
|
Copyright © 2025 Pennyfarthing Tools Ltd - All Rights Reserved | Design: Macwiz Powered by WordPress & Atahualpa |
||
